Cherchenie Vinogradov Reshebnik Rabochaia Tetrad -

The most critical rule for "long pieces" is the dimensioning:

To complete the task for a "long piece" in the , you must use break lines to shorten the visual representation while writing the actual total length on the dimension line. Ensure you include the necessary diameter symbols and any required cross-sectional views to fully define the part's geometry. cherchenie vinogradov reshebnik rabochaia tetrad

Even with a break, use a standard scale (e.g., 1:1 or 1:2) for the ends of the part. The most critical rule for "long pieces" is

For a long part with a constant cross-section (like a shaft or pipe), you should not draw the entire length to scale. Instead, use (линии разрыва). These are typically thin, wavy lines or "Z" shaped zigzag lines drawn by hand or with a ruler, depending on the specific standard (GOST) requirement in your workbook. 2. Prepare the Views For a long part with a constant cross-section

Are you working on a specific exercise number in the or a different volume?

In the context of the (Technical Drawing) workbook by Vinogradov , the task involving a "long piece" (often referred to as a "длинная деталь" or "вал" in Russian) typically focuses on the convention of breaks (разрывы). This technique is used to represent long, uniform objects on a smaller sheet of paper without sacrificing detail at the ends. 1. Identify the Drawing Convention