N_031.mp4 File

: Remove old wires from the terminal block and connect the new assembly.

Detailed wiring diagrams and flowcharts can be found in the PAT DS350 Service Manual or via WIKA Mobile Control Support . LENGTH-ANGLE-RADIUS-LOAD INDICATING SYSTEM n_031.mp4

: Ensure the hoist limit switch stops the winch before the hook hits the boom tip. : Remove old wires from the terminal block

This guide covers the assembly and adjustment of core components found in the system's technical manuals. 1. Cable Reel & Length Sensor This guide covers the assembly and adjustment of

: Measure the signal between Pin 2 (signal) and Pin 1 (ground). Use a voltmeter at test point MP4 on the main board. 2. Angle Sensor Adjustment

: Lower the boom completely to remove rest pressure. Disconnect hydraulic hoses.

: Verify voltage at the sensor. Expected values are roughly 3.125V (0°) and 2.5V (45°) . 3. Pressure Transducer Maintenance