Reliabilt-window-mull-kit-instructions -

: Lay the windows side-by-side on a flat surface. Use a utility knife to trim any excess vinyl "welds" or protruding edges from the corners where the windows will meet to ensure a flush fit.

: Apply additional silicone sealant to the top and bottom of the mull joint, filling any voids. If your kit includes a drip cap or mull bridge , install and seal these over the top and bottom exterior joints. Helpful Resources reliabilt-window-mull-kit-instructions

: If your windows have nailing fins or J-channels on the sides being mulled, remove them using pliers or a utility knife to allow the frames to sit tightly together. : Lay the windows side-by-side on a flat surface

: Open the window sashes to access the factory pre-drilled holes or specific reinforcement areas. Drive the provided screws through one frame into the other (staggering them if necessary) to pull the units tightly together. If your kit includes a drip cap or