Unit Usp 1020d Instruktsiia -

Press the MEM button. It will first show the average of the last 3 readings. Press it again to scroll through previous entries.

Once the measurement is complete, the cuff deflates, and the screen displays: Systolic (top number) DIA: Diastolic (bottom number) PULSE: Heart rate per minute unit usp 1020d instruktsiia

If you have specific like dizziness or frequent high readings, Press the MEM button

4 x AA Batteries (or AC Power Adapter, depending on the bundle) 1 x Instruction Manual & Warranty Card 1 x Storage Case ⚙️ Device Setup Once the measurement is complete, the cuff deflates,

Remove batteries if the device will not be used for more than 3 months.

In memory mode, press and hold MEM and SET simultaneously until "CL" appears on the screen. ⚠️ Error Codes & Troubleshooting Er 1 Sensor is abnormal Check cuff connection and try again. Er 2 Pulse signal not detected Ensure cuff is snug and you remain still. Er 3 Measurement result error Relax for 2 minutes and retake the test. Er 4 Cuff is too loose or leaking Re-wrap the cuff tightly. Low Battery Batteries are drained Replace all 4 batteries with fresh ones. 🧼 Maintenance & Storage Clean the monitor with a soft, dry cloth. Never submerge the cuff or monitor in water. Store in a cool, dry place away from direct sunlight.

With the device OFF, press and hold the button for 3 seconds.